It was just another day browsing 1Addicts when I stumbled upon a thread about custom front splitters by fmxomar. There was a ton of interest, but no one had installed one yet. For the price, I figured I’d pull the trigger on the front splitter and a set of side splitters.
I thought these two items would flow perfectly with the Rieger rear diffuser that I’ve had my eyes on. The parts arrived within a week and came with installation hardware, but no mounting holes. I guess that’s what a drill is for! First step: remove the front bumper.
I started off by clamping the splitter to the bottom of the bumper and then lined everything up. 9 holes later and it was attached. I still wanted to mount the OEM wheel wind deflectors, so I trimmed 1/2″ notches in the back of the splitter to make room.
Because both parts are plastic and the splitter wasn’t structurally mounted, I didn’t want to take the chance of it folding under at high speeds. So, I installed two APR support rods. It took a little courage to drill into a perfectly good front bumper, but it was a risk I was willing to take. I followed the center-flow design and made sure to use large washers on the back of the bumper. Everything was secure so I quickly re-mounted the front bumper. It is a very sturdy setup.
Overall, I am very satisfied with this splitter. I would not recommend mounting it without supporting rods, but feel free to do so at your own risk. Stay tuned for the side-skirt installation in about a month!